Masimo Radical Signal Extraction Manuel de l'opérateur télécharger pdf (Page 32)

2-12 Radical-7 Signal Extraction Pulse CO-Oximeter Operator’s Manual

System Description

Radical-7 Monitor Interface

In addition to being a full-featured Handheld and Standalone Pulse CO-Oximeter, the Radical-7 Pulse

CO-Oximeter’s unique SatShare interface links the Radical-7 Pulse CO-Oximeter to most existing

multiparameter patient monitors through the pulse oximetry patient cable or SpO

input connector.

10.0

■ Upgrades any approved and validated monitor to Masimo SET performance by using the

calculated SpO

and pulse rate determined by Radical-7 to simulate an ideal waveform,

which is sent to the validated multiparameter patient monitor.

■ Connects into the SpO

patient cable or SpO

input connector of the multiparameter

patient monitor.

Refer to Section 3, SatShare Setup and Section 4, SatShare Operation for additional details.

CAUTIONS:

■ THE WAVEFORM DISPLAYED ON THE MULTIPARAMETER PATIENT MONITOR IS

A SIMULATED SIGNAL (NON-NORMALIZED). REFER TO THE RADICAL-7 PULSE

CO-OXIMETER DISPLAY FOR PATIENT WAVEFORM.

■ IF DISPLAYING THE SIMULATED WAVEFORM IS NOT DESIRABLE, IT IS

RECOMMENDED TO TURN OFF THE PLETHYSMOGRAPHIC WAVEFORM DISPLAY

ON THE MULTIPARAMETER MONITOR.

■ ONLY USE A SATSHARE CABLE THAT HAS A FERRITE BEAD INSTALLED.

■ ONLY SpO

AND PULSE RATE CAN BE DISPLAYED ON THE MULTIPARAMETER

MONITOR WITH SATSHARE.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 115 116

Pas de commentaire

Masimo Radical Signal Extraction Manuel de l'opérateur Page 32